Thursday 17 March 2011

Finishing small parts

I have spent the last few weeks finishing various small parts that go into the movement. I want 02 to be absolutely perfect.

Below you can see some of the parts from the keyless work. All the parts have had their flanks & top surfaces straight grained and edges bevelled. The screw heads have been polished.

------------------------------


Part of the cannon pinion & centre pinion will be seen through the minute hand hub. These have been polished too.

------------------------------


The movement screws have had their heads & ends polished. The ends will be visible from the dial side. The flanks of the screw heads have been straight grained.
------------------------------


Here are the dial markers. The heads have been domed & mirror polished. The flanks of the heads are straight grained.

The ends have been polished as well.
------------------------------


The winding wheel has been skeletonised, bevelled & straight grained. The click & transmission wheel have straight grain finish on the top surfaces. I think the wheels will look interesting when the watch is wound since a straight grain finish changes with the light.

------------------------------


The end of the barrel arbour.
------------------------------


The balance spring stud holder (I have left the regulator alone since finishing the top surface will disturb the curb pins).
------------------------------


The crown, castle & intermediate wheels from the keyless work.
------------------------------


and finally, the barrel & motion works.

I hope all this effort pays off :-)

Aditya